Elgar CW 1251P-V Specifikace stáhnout pdf (Strana 14)

Introduction Elgar CW-P Series

0-2 Operation Manual

• 1 phase 45 to 500 Hz AC output; 45-1000 Hz with H–Option.

Units may be connected in multiphase configuration and/or paralleled for higher

powers. (Consult factory for more than two units paralleled.) Multiphase/paralleling

cables are optional.

• Transformer coupled output with disconnect relays

• 0 to 135V and 0 to 270V ranges; 0 to 155V and 0 to 310V ranges with V–Option

• CW 801P and CW 1251P versions have universal output socket on front panel.

All units have output power available at rear of unit.

• Remote sense leads for accurate output voltage

• Input PFC provides maximum utilization of available outlet current and wide range of

input voltage and frequency

• CE mark

• UL/CUL (consult factory for availability)

• GPIB and RS-232 control

• Two large, 7-segment LED, 4-digit displays on front panel

• Set volts, overvoltage, frequency, current, and overcurrent by two front panel

encoders

• Measure voltage, wattage, VA, power factor, current, peak current, and crest factor

• Display overvoltage, frequency, and overcurrent setting

• Over current shutdown or constant current mode menu-selectable

• Enable/disable output voltage rms loop menu-selectable

• Sync in, clock out, and analog programming of output voltage available through rear

panel connector. These items are menu-selectable.

• Front panel lockout; measurement active

• Stored settings including: Power up to previous front panel setting or 0V

• 2-speed fan for low noise

• Side air intake, exhaust to rear

• All connectors on rear

(output power also available at front for CW 801P and CW 1251P)

• Chassis depth 20" (front panel and rear connectors add additional depth)

• Will fit in 24" RETMA rack system

• 1-year calibration interval, covers on soft calibration

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 61 62

Žádné komentáře

Elgar CW 1251P-V Specifikace Strana 14