Elgar CW 1251P-V Specifikace stáhnout pdf (Strana 60)

Programming Elgar CW-P Series

4-8 Operation Manual

4.3.11 RMS Voltage Loop

This entry specifies whether the RMS voltage loop is on or off. When the voltage loop is

turned on, the RMS output voltage is tightly regulated at the sense point and the output

impedance is compensated for. When the voltage loop is off, the output impedance is

not compensated for.

LOOP OFF/ON

4.3.12 Phase A Offset

This setting specifies the offset of the phase A output zero crossing in relation to the

externally applied phase–lock–loop signal in degrees.

CLPH 0..360

4.3.13 Phase B Offset

This setting specifies the offset of the phase B waveform in relation to the phase A

waveform in degrees.

PHB 0..360

4.3.14 Phase C Offset

This setting specifies the offset of the phase C waveform in relation to the phase A

waveform in degrees.

PHC 0..360

4.3.15 Slave Channel

Refer to Section 3.9, Master/Slave Configurations, for usage.

CHAN A, B, or C

4.3.16 Slave Address

Refer to Section 3.9, Master/Slave Configurations, for usage.

ADDR 0..5

4.3.17 Slave Configuration

Refer to Section 3.9, Master/Slave Configurations, for usage.

CONF A0A0–A0C5

1 2 ... 55 56 57 58 59 60 61 62

Žádné komentáře

Elgar CW 1251P-V Specifikace Strana 60